Rope harness techniques - harness with dildo

This tie is secure enough for the same sort of use that you might put a regular strap-on harness to, and has the added benefit of including a lovely karada as well.

Starting out

The first thing you'll need is a suitable dildo. Choose one that has a flat, round base like the one shown here. Dildos with a suction-cup base, a rounded end, or no base at all won't work; the rope holds the dildo flat against the pubic bone by the base.

This particular karada is a little bit different from the one shown in the other karada tutorial. This variant involves making knots along the rope first, before the karada is finished, and the final result looks different. You can make a dildo harness using either type of karada; I've used the knotted karada in this tutorial simply to show a slightly different way to make it.

This harness can also be used on men, minus the dildo. If you're wondering how to tie a karada on a male partner, and you fancy the idea of a little bit of cock bondage, this might be something you'll like. I've demonstrated it on a woman here, but it can be adapted for use on a man easily enough.

As usual, you're going to start by locating the center of your rope. And, as usual, I recommend tying a small piece of thread around the center of your rope so you'll only ever have to look for it once. Make a loop at the middle of the rope and drape it over your partner's shoulders so that the loop hangs down just below the level of your partner's butt. Then tie three knots in the part of the rope that's hanging down, as shown in the second part of the picture. In the front, tie three knots down the front of the rope as shown in the third part of the picture.

When you tie the knots, be sure there's a loop of rope about an inch long or so in the back. The bottom of the knot in the front should be just above the place where you want the dildo to be. Make sure the bottom part of the knot is just at the level of your partner's pubic bone; this knot will determine where the dildo sits.

Put the dildo in place and tie another knot below it to hold it there, as shown in these two pictures. Of course, if you're doing this on a man, you won't need the bottom knot.

Now take the ends of the rope that are hanging down below the dildo, and bring them up between your partner's legs, Pass them through the loop in the back, as shown here.

Now take the part of the rope hanging down and pass it between your partner's legs again. Bring the rope up on each side of the dildo, and cross the two pieces of rope over the top of the dildo like so:

Pass the rope around your partner's body and through the parts of the rope hanging down your partner's back, between the bottom two knots. Then bring it around your partner's body again and through the rope hanging down the front of her body between the bottom two knots. This is one of those things that's easier to show than to explain.

And just keep doing this. Pass the rope around your partner's body, loop it between the knots, and bring it back around. When you reach the top, pass it above the top knot like what you see here.

Finishing the karada

If you're using a 25' length of rope, you've probably run out of rope about here and you can just tie off the ends. If you're using a longer rope, you can easily use up any extra rope you may have by bringing the ends straight down and then wrapping them around and around the lower part of the karada like what you see in this picture. The finished karada should hold the dildo securely in place.

And that's all there is to it!