Ball tie part 3 - knees and legs bondage illustrated technique

Take the two ends, and tie them in a square knot.

Now that her hands are secure, we can tie her knees. Take a 25 to 30-foot rope and double it. Wrap the loop around her legs, just above the knees, and run the ends through the loop.

Reverse the direction, and take a couple more wraps around the legs.

Take the ends of the rope, and run them through the loop that was formed when you changed directions.

Now take three crosswise wraps, making cinch loops. Note that we are not cinching the knees very tight. When the legs are bent, they will expand, tightening up the ropes. If we cinch them too tight now, they will be much too tight when the legs are bent.

Take one of the ends, and run it underneath the knee wraps, then tie the ends together with a square knot.

Now is a good time to gently lay her on her side. It will be much harder to move her once the tie is completed.

Take a 25-foot length of rope and double it. Wrap the loop around her ankles, and run the ends through the loop.

Reverse the direction, so the rope pulls against the loop, and make three or four more wraps around the ankles.

After you have made the wraps, run the rope ends through the loop that was formed when you changed directions.

Now take a few crosswise wraps, to form cinch loops. The ropes should be snug, but not too tight; you don't want to make her feet fall asleep.

After you have done the cinch loops, run the ends underneath the ankle wraps. (Between the two sides of the wraps, not cinching them.) Don't pull it tight yet; leave a little loop.

Now run the ends through the loop you just made, forming a knot. This will keep the ankle wraps from tightening up. Pull the ends of the rope tight. You should have several feet of rope left over.

GO TO THE PAGE 4