Cupcake harness for big breast

For individuals with a breast size of C-cup or larger, carefully and sensually wrapping each breast can dramatically focus attention to this part of the body. This harness shows a way to secure those breast wraps so that they do not slip around by attaching them at multiple points to a modified Basic Chest Harness.

Though the tie may look visually intense, the tie should not be painful without that being a consciously added part of the scene. If you wrap tightly around the breasts, the skin will begin discoloring. It is possible to pop capillaries which creates little red dots on the skin’s surface, especially if you do any impact play (slapping, caning) with the bound breast. Additional care should be taken when wrapping breasts on individuals with breast implants.

An additional 30ft (10 meter) piece of rope was added to the Basic Chest Harness to convert that tie into this more detailed form.

Follow steps 1-10 of the Basic Chest Harness.

Pull ends underneath shoulder strap

Make sure your Bottom is not looking at the chest harness when you do this or else you risk hitting her in the eye if the ends come through at a high speed.

Snug and drop ends over other shoulder

By adding that extra tuck of rope, you have created a decorative twist in the front of the chest harness. Snug the twist down and drop the ends over the other shoulder.

Tie off shoulder straps

Use an overhand knot to tie off around the torso wraps. Tying off around both shoulder straps as shown in step 14 of the Basic Chest Harness is also a valid option.

Split the lines

Once the lines from the shoulder straps are tied off, have one run to the left and one to the right, above the four sets of wraps that went around the torso, just as you did in the Clavicle Exposed Chest Harness.

Pull ends underneath shoulder straps

Pull the left side’s end underneath the left shoulder strap, then create reverse tension. Our goal is to anchor the rope above the breasts so we can bind each breast independently. Repeat on the right side.

Wrap right breast

Hold her right breast in your right hand while slowly wrapping the line around the breast towards the outside of the body. Get the rope as snug to the torso as possible when passing under the breast. Ask your Bottom how snug you can wrap, as everyone has different thresholds and desires for this sort of bondage.

Continue wrapping right breast

Make sure your lines lay right up against one another as you wrap, with no gaps between lines. Stop wrapping when you are either near the end of your line, you run out of breast to wrap, or you are happy with how the harness looks.

Tuck end underneath clavicle pull

Pull the rope under the lower clavicle pull line that was laid in step 15.

Tuck line underneath all the breast wraps

Pulling from next to the chest towards the nipple on the right breast, gently slide the end underneath all the breast wraps. If the wraps are very tight, you may have to tuck the line under one wrap at a time. Make sure not to pull through too fast, lest you cause abrasion.

Bind the left breast

Repeat steps 16-19 on the left breast, holding the breast in your left hand and wrapping around the breast in the opposite direction that you did the first breast. Wrap the same number of times as you did on the right breast, then tuck the end underneath the clavicle pull and all of the breast wraps.

Create shoulder straps

Run the lines from the breast bondage up over each shoulder, lifting the breasts as you do so. This will add snugness to the bondage, and position each breast in the “cupcake” position.

Tie off

Take each line and use them to tie a square knot on the back side. The finished product should appear similar to this on the front and side.